|
|
| Ethernet Interface Converter
|
|
Ethernet has become a standard interface in data communication. The need for remote connectivity among distributed computers and other Ethernet-ready appliances is on the rise. The new network environment today may include small office, classroom, laboratories and even residential homes or apartments.
|
|
xx-Eth to Ethernet Interface Converter
Ethernet has become a standard interface in data communication. The need for remote connectivity among distributed computers and other Ethernet-ready appliances is on the rise. The new network environment today may include small office, classroom, laboratories and even residential homes or apartments.
These networks require a simple solution for connection to WAN. Because WAN access availability differs from place to place, this solution must be able to support different types of communication links. Ethernet converter solutions offer a range of products, and users with the flexibility to choose the WAN link.
xx-Eth series products are high performance, remote, self-learning Ethernet bridges. Their small size and low cost make them ideal for cost-sensitive bridging applications or as LAN extenders or segments over bit-stream type infrastructures.
E1/FE1-Eth 1 *E1 to Ethernet Converter
convert the ITU-T G.703 E1 2.048 Mbps interfaces to Fast Ethernet interface.E1-Eth convert dump E1 to Ethernet, FE1-Eth convert Framed E1 to Ethernet
Line interface: ITU-T G.703 E1, 2048 Kbps
Both impedance balance and unbalance supported
Data port: IEEE 802.3 , fast Ethernet, 10/100M bps
Provide 2 clock types: E1 master clock, E1 line clock.
provide 3 loop functions: local loop, to remote loop, order remote loop.
Have pseudo random code test function, easy the installation and maintenance.
Have Ethernet monitor self-reset function, equipment will not dead.
LED indicator the status of both local and remote side equipment
provide detecting real time Ethernet communication status.
Available as standalone units in lightweight enclosures, or as cards for 4U rack.
FE1-4Eth E1-4*Ethernet Converter
Converter E1 port to 4 Ethernet ports
Internal equip with 5 port Ethernet Switch
Support VALN
The 1st Ethernet port can be set as high priority
Other parameter same with FE1-Eth
V35-Eth V35-Ethernet Converter
convert the V.35 interfaces to Fast Ethernet interface
Other parameter same with FE1-Eth
FE1-V35-Eth Dual port Converter
convert the V.35 to some time slots of E1, convert Ethernet to some time slots of E1,then multiplexer them in uplink E1
Other parameter same with FE1-Eth
FE1-2Eth Dual engine Converter
Equip with 2 engine , each engine convert Ethernet to some time slot of E1, then multiplexer to uplink E1
These two Ethernet is absolute separate in physical layer , can confirm the QOS and security.
Other parameter same with FE1-Eth
2/4/8/16 FE1-Eth 2/4/8/16 *E1 to Ethernet Converter
Also called N*E1 Inverse Multiplexer, transmit 4~16 Mbps Ethernet data over multiple E1 links
Load sharing over redundant links is performed to improve the resilience of high speed connections. If a E1 link fails, the communication link still remains open, but at a reduced speed (automatic rate fallback to lower speeds is supported)
CRC alarm limitation can auto insulate bad-quality transmit channel by configuration, and is single direction insulation. when one direction error rate over limitation, cut only this direction, the other direction not affected.( the two directions need not symmetry.)
Support E1 channel hot plug, and auto detect available E1 channels.
can accept have 10 ms transmission delay, auto stop transmission when the delay above the limitation.
Low cost transport of broadband traffic. Saves the cost of conversion equipment
|
|
|
